Clemco SXS Clemlite Nozzle

Clemco SXS Clemlite Nozzle

SKU: OTS-6032
HAN: 6032
Category: Blast nozzles
Manufacturers: CLEMCO

Type

from

156,39 €

Show B2B prices

incl. 19% VAT , plus (Paket)

Low stock level

This item has variations. Please select the requested variation.

Description

Clemlite Blasting Nozzle Silicon Carbide-Lined Silicone Jacketed Long Venturi

Purpose	A blast nozzle accelerates the air and abrasive as the mixture exits the end of the hose. The taper and length of the nozzle's inlet and outlet determine the pattern and velocity of the abrasive exiting the nozzle. The composition of the liner material determines its resistance to wear.
Requirements for Operation	Nozzles are sized by the diameter of their orifices in 1/16-inch increments. A No. 2 nozzle has a 2/16-inch (1/8-inch) orifice, a No. 3 nozzle has a 3/16-inch orifice, etc. The size of the nozzle orifice determines abrasive and air consumption. When choosing a nozzle, consider the amount of available air in cfm, the capacity of the blast machine and the inside diameter of the piping, and the blast and air hoses. For optimal performance, these elements must be compatibly sized. If a too large nozzle is used, low blast pressure and rapid wear on the blast hose will occur. If a too small nozzle is used, smooth media flow will be difficult to achieve.
Description of Operation	The operator inserts the nozzle washer into a contractor-thread nozzle holder and screws in the nozzle, turning it by hand, until it seats firmly against the washer. With all related equipment correctly assembled and tested, the operator points the nozzle at the surface to be cleaned and presses the remote control handle to begin blasting. The operator holds the nozzle 18 to 36 inches from the surface and moves it smoothly at a rate that produces the desired cleanliness. Each pass should overlap slightly. The operator must replace the nozzle once the orifice wears 1/16-inch beyond its original size.
Advantages	Expected life with expendable abrasives is up to 500 hours Non-binding contractor threads 42% lighter than tungsten carbide
Service	If you need further information do not hesitate to contact us . The offered goods are all high-grade and new.

Material:	Silicon Carbide
Nozzle Length:	165 mm 200 mm 225 mm
Outlet:	1
Exit Angle:	90°
Entrance cone:	32 mm
Connection Thread:	50 mm Coarse Thread
Blast hose diameter:	19 mm; 25 mm; 32 mm
Jacket:	Silicone
Internal diameter (Nozzle):	11 mm 9,5 mm 12,5 mm